机电复合作用下发电电动机磁极连接线建模及应力分析

针对抽水蓄能机组发电电动机转子磁极连接线现有设计校核往往仅考虑单一机械应力作用,提出计及机端短路故障的机电复合作用下发电电动机磁极连接线建模及应力分析方法。首先,基于有限元方法建立某抽水蓄能机组发电电动机转子结构有限元模型,得到磁极连接线不同工况下单一机械应力结果,然后建立机端三相短路故障下发电电动机电磁场有限元模型,得到计及故障下电磁力作用的机电复合应力结果。结果表明,磁极连接线飞逸工况下承受机械应力约为额定工况时的2倍,电磁力对磁极连接线不同区域影响不均,受力方向和大小的变化规律与机械应力不同,机电复合作用下会造成磁极连接线局部应力激增。     

Anatase/rutile-TiO2 hollow hierarchical architecture modified by SnO2 toward efficient lithium storage

Hierarchical architecture of anatase/rutile-mixed phases TiO₂ with hollow interior was successfully fabricated via a Topotactic synthetic method, including the synthesis of CaTiO₃ precursors and transforming them into TiO₂ through ion-exchange process. The as-synthesized TiO₂ hierarchical architectures as the anode materials were used as lithium-ion batteries (LIBs). Compared with TiO₂ samples, the TiO₂@SnO₂-5% shows the improved lithium storage capacity, cycling performance and rate properties. The impedance of the TiO₂ electrode decreases evidently after adding few amount of SnO₂. The hollow hierarchical structure with different compositions provide much more active sites, and well connect interface among anatase, rutile, and SnO₂, facilitating the electron and ion transport quickly and efficiently. Addition appropriate number of SnO₂ not only well kept the hierarchical architecture but also enhanced the capacity and conductivity of the TiO₂ sample. As a result, TiO₂@SnO₂-5% exhibited excellent lithium storage performance.     

[学科发展]机构学中机构重构的理论难点与研究进展——变胞机构演变内涵、分岔机理、设计综合及其应用

生产力发展与工程技术革新要求机构具备可自重组与可重构及“一机多用”的功能，以满足复杂工况需求。可重构机构具有可变活动度和可变构态，可以满足多任务、多工况与多功能的要求，然而，决定其设计方法的演变内涵与分岔机理的研究目前仍不为学者们充分了解。从变胞机构的演变与分岔机理的角度，以旋量理论、李群与李代数及微分流形为主要工具，揭示了机构演变内涵及运动与约束空间的内在关联关系；探究了机构演变中的分岔机理与可控奇异位形，回顾了变胞机构与折纸及折展机构的历史渊源，综述了变胞机构的构型设计、性能综合与新型设计理念及其创新应用。     

[可靠性建模及试验技术]重型机床液压元件油液污染退化量分布剖面可靠性建模

针对重型机床液压系统故障频繁且多与油液中的固态颗粒污染物相关的问题，进行了油液污染趋势变化试验。通过时域分析获得了油样颗粒数的有量纲和量纲一参数，通过Q-Q图和K-S检验分析有量纲参数，污染颗粒数是退化量服从正态分布的退化数据。进行了油液污染与环境相关性分析试验，采用相关系数法分析得到，颗粒数变化量与一定范围内的温度、流量、压力的相关性小；将液压元件分为管路、阀、过滤器三类，用直径5 μm左右的颗粒和直径大于15 μm的颗粒分别研究管路及阀件的堵塞和磨损情况，以过滤器过滤精度大小的颗粒研究过滤器的堵塞情况，设定ISO4406标准20/17级对应的颗粒数为阈值，利用退化量分布建立了液压元件单一故障模式的可靠性模型；利用竞争失效模型将上述模型融合为多故障模式下的可靠性模型。     

Domestic demand-side response with heat pumps: controls and tariffs

ABSTRACT

Electric heat pumps feature prominently in projected energy transitions in the UK and elsewhere. Owing to their high electricity consumption, heat pumps are viewed as important targets for demand-side response (DSR). Findings are presented from a field trial of a new control system that aims to optimize heat pump performance, including under time-varying tariff conditions. The trial involved monitoring 76 properties with heat pumps, but without dedicated heat storage; 31 of these received the control system. Interviews were conducted with a subsample of 12 participants. The controller successfully evened out electricity demand over the day (reducing the evening peak), but this was associated with increased late night and daytime temperatures. Interview participants reported some disturbance owing to overnight heating and noise, as well as usability issues with the controller interface and hardware. These issues present risks to the future acceptability of such systems. While the system delivered short-term demand reductions successfully, longer-term demand shifting risked causing unacceptable disturbance to occupants. Future control systems could overcome some of the issues identified in this pioneering trial through more effective zoning, using temperature caps or installing dedicated heat storage, but these may either limit the available flexibility or be challenging to achieve.     

Structure variation and energy storage properties of acceptor-modified PBLZST antiferroelectric ceramics

Energy storage capacitors with high recoverable energy density and efficiency are greatly desired in pulse power system. In this study, the energy density and efficiency were enhanced in Mn-modified (Pb_0.93Ba_0.04La_0.02)(Zr_0.65Sn_0.3Ti_0.05)O₃ antiferroelectric ceramics via a conventional solid-state reaction process. The improvement was attributed to the change in the antiferroelectric-to-ferroelectric phase transition electric field (E_F) and the ferroelectric-to-antiferroelectric phase transition electric field (E_A) with a small Mn addition. Mn ions as acceptors, which gave rise to the structure variation, significantly influenced the microstructures, dielectric properties and energy storage performance of the antiferroelectric ceramics. A maximum recoverable energy density of 2.64 J/cm³ with an efficiency of 73% was achieved when x = 0.005, which was 40% higher than that (1.84 J/cm³, 68%) of the pure ceramic counterparts. The results demonstrate that the acceptor modification is an effective way to improve the energy storage density and efficiency of antiferroelectric ceramics by inducing a structure variation and the (Pb_0.93Ba_0.04La_0.02)(Zr_0.65Sn_0.3Ti_0.05)O₃-xMn₂O₃ antiferroelectric ceramics are a promising energy storage material with high-power density.     

Can lanthanum doping enhance catalytic performance of silver in direct propylene epoxidation over NaMoAg/SiO_2?

In the attempt to reduce surface free energy of silica to improve interaction of silica with silver, silica was doped by different amounts of low surface energy lanthanum, La_2O_3, through impregnation. The doped and undoped silica were used as supports for preparation of Na/Ag/Mo/La_2O_3-SiO_2 catalysts. Catalytic performances of the catalysts were evaluated in direct epoxidation of propylene(DPO) using molecular oxygen under atmospheric pressure and without adding hydrogen. Adding 5 wt%La to the Na/Ag/Mo/SiO_2 catalyst improves both the catalysts electivity in DPO and its stability over 20h of time-on-stream.The characterization results show that La_2O_3 species interact strongly with silver particles on the silica surface which result in significant improvement in the dispersion profile of silver and marked decrease in the size of silver nanoparticles(AgNPs). The estimated mean diameter of AgNPs is ca. 4.0 nm in Na/Ag/Mo/5 wt%La_2O_3-SiO_2, which is smaller than that(53.9 nm) found in Na/Ag/SiO_2. The presence of subnanometer AgNPs on Ag/La_2O_3-SiO_2 prior addition of MoO_3 and NaCl to the sample can enhance the mutual electronic synergism between Ag, MoO_3 and Na for selective production of propylene oxide.     

盐穴地下储气库密封性的测试与评价

对盐穴储气库系统密封性的测试与评价方法进行了详细介绍。测试方法选取原则、测试相关计算方法以及测试标准为储气库密封性测试的工程设计提供了详实的理论基础。     

塔里木盆地中秋1凝析气藏成藏条件及演化过程

2018年12月,塔里木盆地秋里塔格构造带天然气勘探取得重大突破,中秋1井在下白垩统巴什基奇克组测试获高产工业气流,发现了该构造带迄今为止最大的整装凝析气藏。为了给该构造带下一步油气勘探部署提供依据,在充分利用前人研究成果的基础上,基于岩心、薄片、测井及地球化学分析资料,明确了中秋1大型凝析气藏的油气藏特征和气藏类型,分析了该气藏天然气成藏条件并推演其演化过程。研究结果表明:①中秋1大型气藏属于低含凝析油凝析气藏,天然气为煤成气,主要来自区内侏罗系腐殖型煤系烃源岩;②该构造带能够形成大型油气藏的有利地质条件是三叠系和侏罗系发育的两套巨厚高演化烃源岩、白垩系发育的大型辫状河三角洲规模有效砂岩储层、喜马拉雅晚期以来的构造活动形成的大规模楔状叠瓦构造圈闭、古近系和新近系巨厚膏盐岩形成的优越保存条件,以及油气生成与圈闭形成的良好时空匹配;③该气藏具有先油后气、晚期快速气侵聚集成藏的成藏模式,总体上是一个"早期聚油、晚期气侵、改造调整、快速成藏"的成藏过程。结论认为,该构造带油气成藏条件优越,具有广阔的油气勘探前景。